Moin,
kann mir jemand sagen, ob die Einstellschraube beim HPE Scheinwerfer beim drehen gegen den Uhrzeigersinn den Lichtkegel nach oben oder nach unten verändert ?
Danke
Scheinwerfer HPE einstellen
-
- Beiträge: 658
- Registriert: Mi 15. Aug 2012, 13:01
- Vespa: Vespa
- Land: Niedersachsen
- ADroste
- Beiträge: 694
- Registriert: Fr 12. Jun 2009, 19:21
- Vespa: GTS-300ie hpe E4
- Land: Deutschland
- Wohnort: Bruchköbel
Re: Scheinwerfer HPE einstellen
HTH...
Headlight adjustment
Proceed as follows:
Position the vehicle in running order and with the
tyres inflated to the prescribed pressure, onto a flat
surface 10 m away from a half-lit white screen; en-
sure that the longitudinal axis of the vehicle is
perpendicular to the screen;
Turn on the headlight and check that the boundary
of the light beam projected onto the screen is not
higher than 9/10 or lower than 7/10 of the distance
between the centre of the headlight and the
ground;
If this is not the case, adjust the headlight by fol-
lowing the procedure below.
Turn the handlebar completely to the right.
Insert a screwdriver with a PH2 bit in the hole in
the bottom part of the front handlebar cover.
Use the screwdriver to adjust:
Turn clockwise to raise the light beam and turn
anticlockwise to lower the light beam.
Remove the screwdriver and move the handlebar
to the centre.
Check the height of the light beam and, if neces-
sary, repeat the procedure until it is correctly ad-
justed. ...
Armin
- mikesch
- Beiträge: 10569
- Registriert: Mo 7. Sep 2015, 17:41
- Vespa: ET4 M04
- Land: GER/NRW/OWL
- Wohnort: Warburg
Re: Scheinwerfer HPE einstellen
Im Uhrzeigersinn drehen, um den Lichtstrahl zu erhöhen und drehen
gegen den Uhrzeigersinn, um den Lichtstrahl abzusenken.
gegen den Uhrzeigersinn, um den Lichtstrahl abzusenken.
Der Mensch hat dreierlei Wege klug zu handeln: durch Nachdenken ist der edelste, durch Nachahmen der einfachste, durch Vespa fahren der sinnigste.
-
- Beiträge: 658
- Registriert: Mi 15. Aug 2012, 13:01
- Vespa: Vespa
- Land: Niedersachsen